Daikin BRC7C62 Manual de Instruções descarregar pdf (Página 11)

English 6

Placing the remote controller in the

remote controller holder

Install the remote controller holder to a wall

or a pillar with the attached screw. (Make

sure it transmits)

How to put the dry batteries

(1) Remove the back cover

of the remote controller

to the direction pointed

by the arrow mark.

(2) Put in batteries.

Use two dry cell batter-

ies (AAA.LR03 (alka-

line)). Put dry batteries

correctly to fit their (+)

and (–).

(3) Close the cover

When to change batteries

Under normal use, batteries last about a

year. However, change them whenever the

indoor unit doesn’t respond or responds

slowly to commands, or if the display

becomes dark.

Placing the

remote controller

Slide from above

Removing the

remote controller

Pull it upward

Remote

controller

holder

[CAUTIONS]

• Replace all batteries at the same time, do

not use new and old batteries intermixed.

• In case the remote controller is not used

for a long time, take out all batteries in

order to prevent liquid leak of the battery.

IN THE CASE OF CENTRALIZED CON-

TROL SYSTEM

If the indoor unit is under centralized control,

it is necessary to switch the remote control-

ler’s setting.

In this case, contact your DAIKIN dealer.

• Operating procedure varies with heat

pump type and straight cooling type. Con-

tact your Daikin dealer to confirm your sys-

tem type.

• To protect the unit, turn on the main power

switch 6 hours before operation.

• If the main power supply is turned off dur-

ing operation, operation will restart auto-

matically after the power turns back on

again.

• AUTOMATIC OPERATION can be

selected only by Heat recovery system.

• Cooling only system give selection of FAN

or COOLING OPERATION only.

〈〈FOR SYSTEMS WITHOUT COOL/

HEAT CHANGEOVER REMOTE CON-

TROL SWITCH (Fig. 3)〉〉

Press OPERATION MODE

SELECTOR button several

times and select the OPERATION

MODE of your choice as follows.

 COOLING OPERATION.................. “ ”

 HEATING OPERATION................... “ ”

 AUTOMATIC OPERATION .............. “ ”

 FAN OPERATION............................ “ ”

4. OPERATION PROCEDURE

COOLING, HEATING, AUTOMATIC

AND FAN OPERATION (Fig. 3, 4)

1

01_EN_3P107422-22S.fm Page 6 Tuesday, June 3, 2008 4:51 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comentários a estes Manuais

Sem comentários