
English 15
4) Fit and install the upper case in the lower case while aligning the tabs (6 positions) with the lower
case.
• Be careful so that the wiring may not be caught.
• Remove the protection sheet attached to the upper case.
2. Remove the front panel, and then remove the back plate attached to the back side.
• When removing the front panel, to avoid dropping the panel, tightly hold the front panel while
removing it.
Lower case assy
Hole
Remote controller
wiring (13)
Upper case assy
〈Control panel〉
Tabs (6 positions)
Fig. 23
(accessory)
Screw (M4)
Front panel
Front panel
Back plate
Screw (M4)
Control box lid
Screw
(M4)
Screw (M4)
(6 pcs.)
Terminal block (X1M: 4P)
Screw (M4)
Fig. 24
Wire harness for the
swing motor
3P249378-4D_FM6.book Page 15 Thursday, December 15, 2011 10:00 AM
Comentários a estes Manuais