Daikin FTYN35DV3B ATY35DV2 Especificações Página 49
- Página / 128
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Instructions SiBE01-503
40 System Configuration
2.6 POWERFUL Operation
13
POWERFUL Operation
POWERFUL operation quickly maximizes the cooling
(heating) effect. You can get the maximum capacity.
■
To start POWERFUL
operation
1. Press “POWERFUL button”.
•
POWERFUL operation ends in 20 minutes.
Then the system automatically operates
again with the settings which were used
before POWERFUL operation.
• When using POWERFUL operation,
there are some functions which are not
available.
• “ ” is displayed on the LCD.
■
To cancel POWERFUL
operation
2. Press “POWERFUL button”
again.
•
“ ” disappears from the LCD.
NOTE
■
Notes on POWERFUL operation
•
POWERFUL operation is not available in modes other than cooling or heating.
•
In COOL and HEAT mode
To maximize the cooling (heating) effect, the air flow rate be fixed to the maximum setting.
The temperature and air flow settings are not variable.
1,2
- SPLIT Pair 1
- D-Series 1
- Non Inverter Pair 2
- Table of Contents iii 4
- 1. Introduction 6
- 1.1.3 Inspection after Repair 8
- 1.1.4 Using Icons 9
- 1.1.5 Using Icons List 9
- List of Function 10
- 1. Functions 11
- Functions SiBE01-503 13
- 4 List of Function 13
- Specifications 14
- 1. Specifications 15
- SiBE01-503 Specifications 16
- Specifications 7 16
- 50Hz 220V 16
- Specifications SiBE01-503 17
- 8 Specifications 17
- Printed Circuit Board 18
- Connector Wiring Diagram 18
- 1.1 Indoor Unit 19
- Control PCB 20
- Signal Receiver PCB 20
- Functions and Control 22
- SiBE01-503 Functions 24
- Functions and Control 15 24
- 1.3 Thermostat Control 25
- Compressor ON 26
- Compressor OFF 26
- 1.5 Programme Dry Function 27
- 1.6 Night Set Mode 28
- 1.7 POWERFUL Operation 29
- 1.8 Other Functions 30
- Four way valve 31
- Compressor 31
- 3. Control Specification 32
- 3.6 Heating Peak-cut Control 33
- 3.8 Defrost Control 34
- 26 Functions and Control 35
- System Configuration 36
- 1. System Configuration 37
- Safety precautions 38
- Installation site 39
- Electrical work 39
- System relocation 39
- Names of parts 40
- Indoor Unit 41
- Outdoor Unit 41
- Remote Controller 42
- Preparation Before Operation 43
- Turn the breaker ON 45
- SiBE01-503 Instructions 46
- System Configuration 37 46
- Operation mode 47
- Swing Setting 47
- 1. Press “SWING button” 48
- POWERFUL Operation 49
- 1. Press “POWERFUL button” 49
- 2. Press “POWERFUL button” 49
- TIMER Operation 50
- 1. Press “OFF TIMER button” 50
- 2. Press “CANCEL button” 50
- ATTENTION 51
- Care and Cleaning 52
- [ Maintenance ] 53
- [ Replacement] 53
- Before a long idle period 54
- Trouble Shooting 55
- Case Check 56
- Check again 56
- Disposal requirements 57
- Fault diagnosis 58
- TIMER CANCEL button 58
- It cancels the timer setting 58
- Instructions SiBE01-503 59
- 50 System Configuration 59
- Service Diagnosis 60
- 1. Caution for Diagnosis 61
- Service Diagnosis 55 64
- 56 Service Diagnosis 65
- 4. Troubleshooting 66
- Troubleshooting SiBE01-503 67
- 58 Service Diagnosis 67
- Model Type Connector No 67
- SiBE01-503 Troubleshooting 68
- Service Diagnosis 59 68
- Troubleshooting 69
- Check No.06 69
- Refer to P.67 69
- Service Diagnosis 61 70
- 62 Service Diagnosis 71
- Service Diagnosis 63 72
- 64 Service Diagnosis 73
- Service Diagnosis 65 74
- 5. Check 76
- Check No.07 77
- 5.4 Hall IC Check 78
- Check SiBE01-503 79
- 70 Service Diagnosis 79
- Removal Procedure 80
- 1. Indoor Unit 81
- Removal Procedure 73 82
- Indoor Unit SiBE01-503 83
- 74 Removal Procedure 83
- 1.2 Removal of Front Grille 84
- 76 Removal Procedure 85
- Removal Procedure 77 86
- Removal Procedure 79 88
- Removal Procedure 81 90
- Pull up the electrical 91
- A hook is provided on the 91
- Disengage the four 93
- Signal receiver PCB 93
- Removal Procedure 85 94
- 1.5 Removal of Heat Exchanger 95
- 88 Removal Procedure 97
- 1.6 Install of Drain Plug 98
- 90 Removal Procedure 99
- Disengage hook 100
- Loosen the hexagon 100
- Remove the motor and 101
- Remove a screw on the 101
- Step Procedure Points 102
- SiBE01-503 Indoor Unit 102
- Removal Procedure 93 102
- 2. Outdoor Unit 103
- Top plate 104
- Left side 104
- Outdoor Unit SiBE01-503 105
- 96 Removal Procedure 105
- Procedure Points 105
- 2.5 Removal of Sound Blanket 108
- 100 Removal Procedure 109
- When restoring the 111
- 2.7 Removal of Compressor 112
- SiBE01-503 114
- Others 105 114
- 1. Others 115
- 1.3 Jumper Settings 116
- Others SiBE01-503 117
- 108 Others 117
- Appendix 118
- 1. Piping Diagrams 119
- RYN25DV3B, RYN35DV3B 120
- ARY20DV2, ARY25DV2, ARY35DV2 120
- 1.2 Outdoor Units 121
- 3D048806 122
- 2. Wiring Diagrams 123
- ARY35DV2 124
- Drawings & Flow Charts 127
- Cautions on product corrosion 128
Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Daikin FTYN35DV3B ATY35DV2
(218 páginas)
(15 páginas)
(12 páginas)
(72 páginas)
(28 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais